Cadac CDC four User Manual download pdf (Page 20)

Revision 1 2012-13 CDC FOUR

The SEL button

Each fader (except the stereo master) has a SEL button in addition to the usual

MUTE and SOLO. The channel for which the CAM is active is selected by

pressing SEL. Only one SEL button can be selected at a time.

Thus, if the SEL button above Fader 5 is pressed, the CAM will adjust the

parameters of whatever signal is currently assigned to that fader. (Note that each

fader, and hence each SEL button, may be assigned to one of up to ve possible

signals within the mixer. This concept is discussed further under “Layers”, see

page 23.)

The controls on the CAM are now discussed in more detail:

Input stage:

TRIM - input gain trim.

48v – phantom power at the mic input.

REV – phase reverse.

HPF – variable-frequency high-pass lter.

HPF – high-pass lter frequency.

Dynamics section:

GATE: THR – noise gate threshold.

GATE: IN – noise gate in/out.

COMP: THR – compressor threshold.

COMP: RAT – compressor ratio.

COMP: LVL – compressor gain make-up.

COMP: IN – compressor in/out.

COMP: AUT – sets compressor attack/release times automatically

COMP: VIN – selects “vintage” compressor algorithm.

LIM: THR – limiter threshold.

LIM: IN – limiter in/out.

BYP – dynamics section in/out.

PST – dynamics section post-EQ.

Delay section:

DLY – delay time.

DLY: IN – delay in/out.

CH 1

∞

ST 1

GP 1

CH 17

CH 33

SEL

SOLO

MUTE

TRIM

HPF

48V

REV

HPF

SmS

20:11:1

LIM

THR

DLY

COMP

GATE

LVL

RAT

THR

AUT

VIN

BYP PST

SmS

DLY

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 82 83

Comments to this Manuals

No comments

Cadac CDC four User Manual Page 20

Comments to this Manuals

Related products and manuals for Control panel Cadac CDC four